EASYFELT P

Description

Oxidized bituminous waterproofing membrane

 

Easyfelt P is a polyester reinforced bituminous waterproofing membrane, manufactured from a mixture of oxidized bitumen. The bituminous compound exhibits high heat and UV stability.

Properties

  • Excellent resistance to positive water & vapor pressure
  • Good dimensional stability under tension
  • Resistant to water borne chemicals
  • Excellent tensile, tear and puncture resistance

Documents and Downloads

Technical Data Sheet
EASYFELT P
Download TDS

This TDS is applicable for the United Arab Emirates only. Please contact your local Polybit sales office for the available TDS in your region

Step by step

SURFACE PREPARATION

The Clean all surfaces thoroughly of all contaminants like dust, traces of curing compound, oil, grease.

PRIMING

Apply Polyprime SB (Solvent based primer) @ 4-6 m²/L by brush, roller or spray. Allow the primer to dry prior to the application of the membrane. Application Easyfelt P membranes are installed by using a cylinder fed propane gas torch. Heat is applied to both the roll and the exposed laps of the membrane being overlapped onto.
Caution: Do not over torch the membrane as this will expose the reinforcement and cause damage to it.

SEALING

Heat both the overlaps and use round tipped trowel to seal the overlap.

UP STAND

An appropriate flashing membrane (Bituplus G) shall be lapped with the base membrane and taken up on the parapet wall and tucked into a groove cut into the concrete. The grooves will be sealed with a suitable mastic.